Starting XServer

You can start XServer by double-clicking on the XSession icon from the WinaXe Programs' folder.

XServer will be started in a default window mode (according to settings stored in the ini-file used). When XServer is running, you can change the current window mode by selecting an appropriate item from the XServer's Control menu or by launching the XSettings utility. (See section Using XSettings in Chapter Configuring WinaXe.)

You can launch XSettings either from the WinaXe Programs' folder or from the XServer's Run menu. If you save new settings from XSettings in the ini-file, then you must restart XServer to re-read the file and to take them effect.

Also, see section Using ComSetup in Chapter Configuring WinaXe on how to make communication settings relating to the networking aspects of WinaXe that operate with the TCP/IP transport interface.

There are some additional settings you can specify to customize your X-sessions. They are described in section The "[XSETUP]" Section of the ini-file below.